Untitled Document
Home Gift Certificates Getting Started Tech Tips
       
concrete
mould making and casting Ready Made Moulds arts and crafts  
   
                                        
Mould Making Silicone
back to main Molding silicone usually comes in a two component form Part A base and a Part B accelerator which after mixing in the proper ratio cures at ordinary room temperatures to a flexible, strong RTV (room temperature vulcanizing) rubber mould.

Silicone rubber has the ability to retain very fine detail. Fortunately most solvents do not attack silicone. However one of the most important features is that almost nothing will stick to silicone. This simplifies the mould making procedures in that no release agents or model pre-preparation are usually necessary.

In fact the only reason why you would not use molding silicones for most of your mould making functions is cost. If your silicone costs are high, examine the use of polyurethane as an alternative.



Check your cart
Categories
       

 

Home
 
Privacy Policy
 
Contact Us